MBHP JDM R2 Orderlist (last update: 08-2004)
+-------+----------------------------------------------+-------+--------------------+
| Loc.  | Description                                  | Qty   | Mouser Part #      |
+-------+----------------------------------------------+-------+--------------------+
| R1-2  | Resistor 10 kOhm                             |     2 | 291-10K            |
| R3    | Resistor 1.5 kOhm                            |     1 | 291-1.5K           |
| D1-4  | Diode 1N4148                                 |     4 | 78-1N4148          |
| D5    | 8.2V Zener Diode                             |     1 | 78-1N4738A         |
| D6    | 5.1V Zener Diode                             |     1 | 78-1N4733A         |
| C1    | Electrolytic Capacitor 100uF (8mmDIA-3.5mmLS)|     1 | 140-HTRL35V100     |
| C2    | Electrolytic Capacitor 22uF (5mmDIA-2mmLS)   |     1 | 140-HTRL16V22      |
| Q1-2  | Transistor BC547A, or BC547B, or BC547C      |     2 | 625-BC547A         |see note 1
| IC1   | IC-Socket for PIC                            |     1 | 571-3902625        |
| J1    | 9 pin serial connector, female               |     1 | 152-3409           |
| ----- | 1:1 COM (RS232) cable --- same as LTC!       |     1 | 172-0906           |
| J2    | 2-row SIL Headers (10 pins) OPTIONAL         |     1 | 517-2380-6221TN    |see note 3
| ----- | Ribbon cable per foot                        |     1 | 517-3365/16FT      |see note 2
+-------+----------------------------------------------+-------+--------------------+
Notes:
1:  Outside Europe the BC547 is hard to find (Mouser has it), the 2N3904 is a good replacement
    But note that the outer pins (E and C) are exchanged - you have to upturn the
    transistor to get the E, B, C pin matching with the PCB
2.  The ribbon cable is only listed here for those who don't already have some.
3.  You only need to install J2 and the long jumper wires if you need in circuit programming,
	Current MIDIbox designs don't use/need this.
4.	Dimensions found after the capacitor values correspond to fit SmashTV's PCB layouts 
    (13mmDIA-5mmLS=13mm diameter casing with 5mm lead space between holes for the pins)